ECONOMICAL "H" BEAM STEEL RODS - learn more about our connecting rods
Manley "H" Beam connecting rods are manufactured from 4340 forgings to the same exacting standards developed and approved by our original equipment customers. There is a vast difference in quality between a Manley "H" Beam and the "other" inexpensive H-Beams on the market. Weight matched to +/- 1.5 grams. Perfectly round big and small ends. Bend and twist is tightly controlled. |
 |
| Part No. |
Center-to Center |
Big End Bore |
Big End Width |
Pin End Width |
Pin Bore |
Gram Weight |
 |
| 4.6 L Stock length w/ 22 mm pin |
|
| 14042-8 |
5.933" |
2.239" |
.940" |
.940" |
.8671" |
602 |
|
|
| 4.6 L Stock length w/ .912" pin |
|
| 14043-8 |
5.933" |
2.239" |
.940" |
.940" |
.9131" |
598 |
|
|
| 4.6 L Stroker w/ 22 mm pin and a 2.000" crank journal |
|
| 14044-8 |
5.850" |
2.125" |
.940" |
.940" |
.8671" |
612 |
|
|
| |
PRO SERIES LIGHTWEIGHT "I" BEAM STEEL RODS - learn more about our connecting rods
Manley Pro Series connecting rods are forged from aircraft quality 4340 vacuum degassed material. Each rod is fully machined in the Manley Lakewood, NJ factory to the highest standards. Our signature "Pro Series Lightweight" design combines the appropriate weight and rugged strength for ultimate horsepower applications. Each rod is shot peened after machining and magnafluxed. Bores are held to exacting tolerances. Bend and twist is tightly controlled. Cap fasteners are ARP 2000 alloy cap screws. |
 |
| Part No. |
Center-to Center |
Big End Bore |
Big End Width |
Pin End Width |
Pin Bore |
Gram Weight |
|
| 4.6L Stock Length w/22mm pin |
|
| 14318-8 |
5.933" |
2.239" |
.940" |
.940" |
.8671" |
602 |
|
|
| 4.6 L Stroker w/ 22 mm pin and a 2.000"" crank journal |
|
| 14320-8 |
5.850" |
2.125" |
.940" |
.940" |
.8671" |
603 |
|
|
